Users can toggle between 10 SPS (Samples Per Second) for low noise and 80 SPS for faster response times, depending on whether the RATE pin is pulled high or low.
Verify voltage dividers and gain settings (128 or 64). 🛠️ How to Install the HX711 Library in Proteus hx711 proteus library
| Problem | Possible Cause | Solution | |---------|----------------|----------| | HX711 not found in library | Files in wrong folder | Re-copy to correct LIBRARY path | | “Model not found” | Missing .HEX or .MOD file | Copy model to MODELS folder | | No data output | Wrong pin mapping | Check DT and SCK connections | | Constant zero reading | A+/A- shorted or gain too low | Add differential voltage, set gain = 128 | | Fluctuating values | Missing decoupling capacitor | Add 100nF near HX711 VCC/GND | | Simulation too slow | Proteus model issue | Reduce simulation speed or use simplified model | Users can toggle between 10 SPS (Samples Per
| Feature | Status | |--------|--------| | Works in Proteus 7/8 | ✅ Yes | | Supports load cell simulation | ✅ Yes (basic) | | 100% accurate timing | ⚠️ Approximate | | Good for learning | ✅ Yes | hx711 proteus library